FREE SHIPPING on orders over $99! Some exclusions apply.
Need Help? Use Our Ramp Calculators

Restyler Magna Ramps

From
$1,649.00
ITEM restyler-magna-ramps
Select Width:
Make a selection to see availability

Safely and easily lift your vehicle up 14 inches for vinyl wrapping, detailing, installing paint protection, display, or maintenance with our Restyler Magna Ramps. Featuring an angle of approach of 10.36 degrees, the ramp system is available in a 16-inch width (for tires up to 14 inches wide) and a 20-inch width (for tires up to 18 inches wide). The system accommodates wheelbases from 82 to 128 inches, and both sizes include steel strips built into the ramp for directly holding magnetic tools and/or a magnetic shelf. Each Restyler Ramp consists of five interlocking pieces that combined weigh only 110 pounds, with no one piece weighing more than 40 pounds!

Once the car is safely on the blocks, the center "bridge" piece can be removed from each side for easier access underneath the car, or for use as a bench or step stool for better access to the whole vehicle. The incline portion can also be removed to give you more freedom to move around the car. The ramp system has a total vehicle weight capacity of 6,000 pounds and comes with one pair of inclines. For either width, an additional set of inclines is available that will interlock to the front and enable a vehicle to smoothly drive up and down both ends. This convenient and portable setup is great for use in the shop as well as when you're on-the-go to other job locations. If you're working with cars really low to the ground (Lamborghinis and Ferraris!), optional XTenders can decrease your angle of approach to only 6.8 degrees, allowing you to work on virtually any car without banging up its nose.

Angle of Approach
Angle of Approach
10.36 degrees
Weight Capacity
Weight Capacity
1500 lbs. per ramp
Sold in Pairs
Sold in Pairs
2 ramps included
100% SOLID
100% SOLID
Exclusive high-density foam
Anti Slip/Skid
Anti Slip/Skid
stays in place on any surface
Restyler Magna Ramps
30 Day Guarantee
Satisfaction or money back
Restyler Magna Ramps
Made in USA
and proud of it

Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object. You may need two sets of hands to get an accurate measurement here.

YARDSTICK TEST

1

Place a 36" yardstick or tape measure at the base of your front wheel.

2

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler).

3

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure. Record that height below in inches.

Specifications
Pair
225"
14"
14"
6,000 lbs.
10.4°
Expanded foam with traction coating
Black
Usage
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Reviews // Q&A