FREE SHIPPING on orders over $99! Some exclusions apply.
Need Help? Use Our Ramp Calculators

Solid Rack Ramps - Low Approach Angle

Free Shipping
From
$165.00
ITEM rack-ramps
Select Approach Angle Degree:
Select Width:
Make a selection to see availability

Rack Ramps provide an easy way to protect the front end of your low-riding car when getting it onto a service platform or lift. Available in multiple sizes, these ramps decrease the angle of approach to as low as 6.3 degrees and are available in several different top designs to suit multiple rack styles or personal preference. Notch cut out, bridge, or hook designs offer alternate methods of snuggling up the ramp to the rack. Each variation is sold as a set of two, and each ramp can hold up to 1,500 pounds for a total vehicle weight capacity of 6,000 pounds.

You won't break your back positioning these - all of the ramps styles weigh under 20 pounds. These ramps are constructed using an exclusive, patent process. They are 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. They will never rust, transfer heat or cold, and won't skid or scuff your floors.

Solid Rack Ramps - Low Approach Angle
30 Day Guarantee
Satisfaction or money back
Solid Rack Ramps - Low Approach Angle
Made in USA
and proud of it
Sold in Pairs
Sold in Pairs
2 ramps included
Anti Slip/Skid
Anti Slip/Skid
stays in place on any surface
Weight Capacity
Weight Capacity
1,500 lbs. per ramp
100% SOLID
100% SOLID
Exclusive high-density foam

Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object. You may need two sets of hands to get an accurate measurement here.

YARDSTICK TEST

1

Place a 36" yardstick or tape measure at the base of your front wheel.

2

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler).

3

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure. Record that height below in inches.

Specifications
Pair
1,500 lbs.
Expanded foam with traction coating
Black
Usage
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Reviews // Q&A