5" H Lip Nose Rack Ramp - 8.6 Degree Approach Angle
Avoid the struggle of dragging heavy steel ramps into position to help your front end clear your lift or platform! Instead, reach for a lightweight set of our 40-inch long hook-nose Rack Ramps.
They have an 8.6-degree approach angle and come with a 3-inch lip bridge. The 14-inch width works with tires up to 12 inches wide. Each rack ramp weighs 9 pounds, and can support up to 1,500 pounds for a total vehicle weight capacity of 6,000 pounds. From the ground to the underside of the ramp lip measures 5 inches, and the ground to the top of the ramp lip measures 5.5 inches.
These ramps are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable.
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Then shop for any Race Ramps with an angle equal to or less than your result.
Place a 36" yardstick or tape measure at the base of your front wheel.
Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).
Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.