Trailer Side Kicks
Key Features:
- 100% Solid lightweight high-density foam with traction coating
- Load your trailer with ease and precision
- 13 Degree approach angle

The Trailer Side Kick is helpful both for parking your vehicle inside your trailer and for changing a trailer tire.
For parking inside a trailer, the Side Kick fits in front of a trailer's wheel wells to provide a tapered, protective guide between your vehicle's wheels and the trailer's steel wheel wells. For changing a trailer tire, simply drive the good tire onto the ramp and the flat tire will be lifted off of the ground for easy removal and replacement. The Side Kick can be used on any level surface without sinking - we're talking pavement, grass, or even sand. No problem!
The Side Kick provides 7.5 inches of lift with a 13-degree angle of approach. Weighing in at only 8 pounds, it can still hold up to 1,500 pounds for a total vehicle weight capacity of 6,000 pounds. This ramp is manufactured with 100% solid, high-density foam with a rugged anti-slip coating. This patented process results in a product that is extremely lightweight, yet strong and durable. It will never rust, transfer heat or cold, and won't skid or scuff your floors. It is sold individually.
- 100% Solid lightweight high-density foam with traction coating
- Load your trailer with ease and precision
- 13 Degree approach angle
- Easily change your tandem axle trailer tire
- Sold individually or as a set of two
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.