Show Ramps - 4.75" Lift for 12" W Tires
Key Features:
- Double-incline ramps have 4.75" of lift and can support 1,500 lbs. each
- Set of two ramps included; fit tires up to 12" wide
- Lightweight yet durable at 5 lbs. each
Show Ramps are a quick, easy way to improve your vehicle display at a show. These double incline ramps can be used to raise up the front, back, or side of the car; or get two sets and raise up the entire body!
They are a great lightweight alternative to jack stands, floor jacks, and wooden blocks. Paired with an accessory like a show mirror, they make for an impressive display that is easy to set up and transport. They can be used with tires up to 12 inches wide, and provide 4.75 inches of lift. They weigh only 5 pounds each and are small enough to fit in your trunk – which they will not damage! Each ramp can hold up to 1,500 pounds for a total vehicle weight capacity of 6,000 pounds.
These Show Ramps are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable.
- Double-incline ramps have 4.75" of lift and can support 1,500 lbs. each
- Set of two ramps included; fit tires up to 12" wide
- Lightweight yet durable at 5 lbs. each
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.
Place a 36" yardstick or tape measure at the base of your front wheel.
Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).
Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.