Skip to Main Content Skip to Footer Content

56" Race Ramps - 10.8 Degree Approach Angle

Starting at
$351.62
MSRP
Pricing shown as of 5/7/2026. Please note that prices are subject to change without notice.
Select Description
ITEM #56-race-ramps
Free Shipping
Make a selection to see availability
Technology & Features
Tire Width
Tire Width
10" maximum width
Angle of Approach
Angle of Approach
10.8 degrees
Weight Capacity
Weight Capacity
1500 lbs. per ramp
Sold in Pairs
Sold in Pairs
2 ramps included
Lightweight
Lightweight
10 lbs. per ramp
High Density Foam
High Density Foam
Exclusive high-density foam
Anti Skid
Anti Skid
stays in place on any surface
Race Ramps™ 56
30 Day Guarantee
Satisfaction or money back
Race Ramps™ 56
Made in USA
and proud of it
Specifications
Made in the USA
Sold As:
Pair
Length:
56"
Width:
12"
Height:
10"
Weight:
10 lbs.
Lift Height:
8"
Maximum Capacity:
1,500 lbs.
Maximum Tire Width:
10"
Approach Angle Degree:
10.8°
Material:
Expanded foam with traction coating
Color:
Black
Usage Guidelines
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.v

This product is backed by a One Year Warranty.

WARNING: This product can expose you to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Calculator
Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.

You may need two sets of hands to get an accurate measurement.

YARDSTICK TEST
yardstick test steps mobile
yardstick test step1
1

Place a 36" yardstick or tape measure at the base of your front wheel.

yardstick test step2
2

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

yardstick test step3
3

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.

Record your height here.
Reviews
The average rating for this product is 5 out of 5 stars 192 Reviews
Q&A