Xtenders for 56" and 67" Ramps – 6.6 Approach Angle
Our Xtender Ramps are designed to work with our 56-inch and 67-inch Race Ramps to create a lowered angle of approach for low profile cars.
The Xtenders are a handy resource for garages and auto shops that work with multiple makes and models, or for the home enthusiast who might just need a slightly gentler incline to accommodate a new car, or a modded car with a lip or splitter. The 12-inch width extensions fit the 56-inch ramps, and the 14-inch width extensions fit the 67-inch ramps. Once your car is parked at the top of your ramps, the extensions can be removed for additional work space – just remember to put them back before you drive down!
These ramp extensions are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. Please note: These Xtender ramps are designed to be used with 56-inch or 67-inch Race Ramps only. If you need a low angle of approach and would prefer not to use an extension, our 72-inch Race Ramps have a 6.8-degree approach angle and are a nice alternative.
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Then shop for any Race Ramps with an angle equal to or less than your result.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.