FREE SHIPPING on orders over $99! Some exclusions apply.
Need Help? Use Our Ramp Calculators

80" Multi-Purpose Combo Ramps

$443.00
ITEM RR-80-10-2
In Stock. Delivered in 3 to 5 Business Days

80-inch Combo Ramps are the "triple header" of ramps - use them as service ramps in the garage, trailer ramps when loading, and wheel cribs for display or service. Weighing in at 22 pounds per ramp, they can hold up to 1,500 pounds each, for a total vehicle weight capacity of 6,000 pounds. The Combo Ramps allow for easy access to the underside of the vehicle, raising it 10 inches with an 8.5-degree angle of approach. The incline section of the ramp can be removed to provide maximum access underneath the car.

If you flip the incline section over, it can be used as a trailer ramp to safely and easily get low-to-the-ground vehicles on and off your trailer. Simply place your existing ramps, or trailer door, on the notch of the Combo Ramps to reduce the angle of approach to 8.5 degrees. Note that the successful use of this application will vary depending on the trailer and vehicle clearance. To learn more about what angle of approach you will need, see the calculator here. These ramps are constructed using an exclusive, patent process. They are 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. They will never rust, transfer heat or cold, and won't skid or scuff your floors.

Tire Width
Tire Width
12" maximum width
Angle of Approach
Angle of Approach
8.5 degrees
Weight Capacity
Weight Capacity
1500 lbs. per ramp
Sold in Pairs
Sold in Pairs
2 ramps included
Lightweight
Lightweight
22 lbs. per ramp
100% SOLID
100% SOLID
Exclusive high-density foam
Anti Slip/Skid
Anti Slip/Skid
stays in place on any surface
80
30 Day Guarantee
Satisfaction or money back
80
Made in USA
and proud of it

Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object. You may need two sets of hands to get an accurate measurement here.

YARDSTICK TEST

1

Place a 36" yardstick or tape measure at the base of your front wheel.

2

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler).

3

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure. Record that height below in inches.

RR-80-10-2 80 Multi-Purpose Combo Ramps
Specifications
Pair
80"
14"
12-1/4"
22 lbs.
10"
1,500 lbs.
12"
8.5°
Expanded foam with traction coating
Black
Usage
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Reviews // Q&A