FREE SHIPPING on orders over $99! Some exclusions apply.
Need Help? Use Our Ramp Calculators

48" Solid Rack Ramp Wide - 6.4 Degree Approach Angle

Free Shipping
Select Approach Angle Degree:
Select Width:
In Stock. Delivered in 3 to 5 Business Days

The 48-inch Long Extra Wide Rack Ramps provides an easy way to protect the front end of your low-riding car when getting it onto a service platform or lift. They ramp decrease the angle of approach to 6.4 degrees and comes with a 3-inch hook. These ramps are constructed using an exclusive, patent process. They are 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. This ramp will never rust, transfer heat or cold, and won't skid or scuff your floors, and it can hold up to 1,500 pounds for a total vehicle weight capacity of 6,000 pounds. It is incredibly lightweight at 15 pounds per ramp, and measures 20 inches wide.

30 Day Guarantee
Satisfaction or money back
Made in USA
and proud of it
Sold in Pairs
Sold in Pairs
2 ramps included
Angle of Approach
Angle of Approach
6.4 degrees
Anti Slip/Skid
Anti Slip/Skid
stays in place on any surface
15 lbs. per ramp
Tire Width
Tire Width
18" maximum width
Weight Capacity
Weight Capacity
1,500 lbs. per ramp
100% SOLID
100% SOLID
Exclusive high-density foam

Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object. You may need two sets of hands to get an accurate measurement here.



Place a 36" yardstick or tape measure at the base of your front wheel.


Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler).


Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure. Record that height below in inches.

RR-RACK-HN20-5 48 Solid Rack Ramp Wide - 64 Degree Approach Angle
15 lbs.
1,500 lbs.
Expanded foam with traction coating
3" hook
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Reviews // Q&A