4" H Car Lift Ramps – 3.9 Degree Angle of Approach
There’s nothing as frustrating as trying to work on a car only to realize that it won’t fit on your shop or home lift! Luckily, these 4-inch Car Lift Ramps make it easier than ever to get that low vehicle up on a scissor or 2-post lift.
They come as a pair; each ramp weighs about 40 pounds total and is compromised of four interlocking pieces. Each side can hold up to 3,000 pounds for a total vehicle weight capacity of 6,000 pounds. Featuring a nice, easy 3.9 angle of approach, they are sloped enough to accommodate the majority of lowered and low profile vehicles. The 185-inch length supports wheelbases from 80 inches to 115 inches long, and the 14-inch width is perfect for tires up to 12 inches wide.
These lift ramps are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. They won’t slide on any surface, including garage and workshop floors.
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Then shop for any Race Ramps with an angle equal to or less than your result.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.