20" Wide Restyler Ramps - Classic Model
The 20-inch wide Restyler Ramps Classic Model is exactly what you need in your shop for installing vinyl wrapping, paint protection and detailing as well as regular vehicle maintenance.
Developed by professionals for professionals, this portable wrap ramp system provides 14 inches of vehicle lift for better access to those tough-to-reach places. With an approach angle of 10.36 degrees, the 20-inch wide Restyler Ramp Classic Model accommodates wheelbases from 82 to 128 inches and tire widths up to 18 inches. The ramp system comes in five interlocking pieces, and once a car has been safely driven up and onto the blocks, the center pieces of the platforms can be pulled out and used as a step up, or removed to reach the underside of the vehicle. No piece weighs more than 40 pounds, making this system a great choice for on-location jobs in addition to regular shop use. The Restyler Ramps Classic Model a total vehicle weight capacity of 6,000 pounds.
The Restyler Ramps Classic Model is manufactured using an exclusive, patented process. It is constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. It won't slide on any surface, including garage and workshop floors.
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Then shop for any Race Ramps with an angle equal to or less than your result.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.