3" Trak-Jax Ramps with 1.5" Stop – 7.8 Degree Approach Angle
Trak-Jax ramps were inspired by an auto-crosser who didn't want to buy a new high-priced, low-profile jack just to change his tires at the track. Lightweight and portable, they go where you go.

These ramps lift your car 3 inches so that you can fit a standard floor jack underneath, and come with a 1.5-inch stop to gently alert the driver that they're at the top of the ramp. They're small and lightweight at only 5 pounds per ramp, so you can easily toss them in the trunk of your sports car for your day at the track. They can accommodate tires up to 10 inches wide, and support up to 1,500 pounds per ramp.
Trak-Jax are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight solution that is strong, yet durable.
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace.
Then shop for any Race Ramps with an angle equal to or less than your result.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.