Xtenders for 56" Race Ramps – 6.6 Degree Approach Angle
Key Features:
- Extension for 56" Race Ramps
- Decrease angle of approach to only 6.6 degrees
- Set of two

These Xtender Ramp extensions are designed to work with our 56-inch Race Ramps, and they reduce the angle of approach to 6.6 degrees for low profile cars.
They are a handy resource for garages and auto shops that work with multiple makes and models, or for the home enthusiast who might just need a slightly gentler incline to accommodate a new car, or a modded car with a lip or splitter. They can accommodate tires up to 10 inches, and only weigh 10 pounds apiece. Once your car is parked at the top of your ramps, the extensions can be removed for additional work space – just remember to put them back before you drive down!
These ramp extensions are manufactured using an exclusive, patented process. They are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. Please note: These Xtender ramps are designed to be used with 56-inch Race Ramps only. If you need a low angle of approach and would prefer not to use an extension, our 72-inch Race Ramps have a 6.8-degree approach angle and are a nice alternative.
- Extension for 56" Race Ramps
- Decrease angle of approach to only 6.6 degrees
- Set of two
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.