Skip to Main Content Skip to Footer Content

42.3" Compact Tow Ramps - 5.2 Degree Approach

$294.00
Select Length
Select Description
ITEM #BT-TT-7-10-IS
Free Shipping
Made to Order, 6-8 Week Lead Time

Key Features:

  • Easily extend rollback for faster, safer loading of low-profile vehicles
  • Decrease angle of approach to as little as 5.2 degrees
  • Compact ramp design supports vehicles up to 10,000 lbs.

See More…

Technology & Features
Tire Width
Tire Width
12" maximum width
Angle of Approach
Angle of Approach
5.2 degrees
Weight Capacity
Weight Capacity
2500 lbs. per ramp
Sold in Pairs
Sold in Pairs
2 ramps included
Lightweight
Lightweight
10 lbs. per ramp
100% SOLID
100% SOLID
Exclusive high-density foam
Anti Slip/Skid
Anti Slip/Skid
stays in place on any surface
42.3
30 Day Guarantee
Satisfaction or money back
42.3
Made in USA
and proud of it
Specifications
Made in the USA
Sold As:
Pair
Length:
42-3/10"
Width:
10"
Height:
4-1/2"
Weight:
10 lbs.
Approach Angle Degree:
5.2°
Maximum Capacity:
2,500 lbs.
Lift Height:
4-1/2"
Color:
Black
Material:
Expanded foam with traction coating
More Information

Tow like a pro with the 42.5-inch long Compact Single Piece HD Tow Ramp! You know that your customer loves his or her Corvette, Porsche, or other low-to-the-ground car, and you need to show them that it's safe in your hands too.

The 1 inch by 5 inch notch in this Tow Ramp enables you to simply fold the rollback down into the notches and drive on up (or hook up the winch) with no worries about your safety or the safety of the car. This compact ramp gives 4.5 inches of lift and has a 5.2-degree angle of approach. It is designed for tires up to 8 inches wide, and it can support up to 2,500 pounds for a total vehicle weight capacity of 10,000 pounds.

These ramps are constructed using an exclusive, patent process. They are 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. The ramp will not slide, scratch, or otherwise damage any floor type. The reinforced bottom allows the ramp to be used on gravel or other rough surfaces that you may encounter along the side of the road.

  • Easily extend rollback for faster, safer loading of low-profile vehicles
  • Decrease angle of approach to as little as 5.2 degrees
  • Compact ramp design supports vehicles up to 10,000 lbs.
Usage Guidelines
Please ensure that your ramp is damage-free before use. Never use two ramps on the same side of the vehicle. Use on a flat, level surface and ensure that the ramp makes full contact with the ground. Check that your steering wheel is straight and drive up at a slow, steady pace. See instruction manual link to review full usage guidelines.

We stand by our Products! All Race Ramps purchases are backed by a 1 year warranty and are guaranteed to be free of defects at time of purchase.

Instruction Manual
WARNING: This product can expose you to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Calculator
Make sure you can sail right up your service ramps!

Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.

To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.

You may need two sets of hands to get an accurate measurement.

YARDSTICK TEST
yardstick test steps mobile
yardstick test step1
1

Place a 36" yardstick or tape measure at the base of your front wheel.

yardstick test step2
2

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

yardstick test step3
3

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.

Record your height here.
Reviews
Q&A