XTenders Extensions for 7" Tow Ramps
Key Features:
- Extension for 7" H Tow Ramps
- Further decreases angle of approach for low-profile cars
- May also be used as a "humper" ramp

This set of two XTenders can only be used with 7-inch lift HD Tow Ramps to further lower the angle of approach. Simply place the XTenders on top of the Tow Ramps and drive on up!
The XTenders can also be inverted for use as a "œhumper" ramp to get a bit of additional lift when needed. They are 10 inches wide and 35 inches long, weighing 6 pounds each.
These extenders are constructed using an exclusive, patent process. They are 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. They will not slide, scratch, or otherwise damage any floor type. The reinforced bottom allows them to grip tow ramps and to be used on gravel or other rough surfaces that you may encounter along the side of the road.
- Extension for 7" H Tow Ramps
- Further decreases angle of approach for low-profile cars
- May also be used as a "humper" ramp
- Set of two
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.