XTenders Extensions for 7" Tow Ramps
$237.37
MSRP
Pricing shown as of 5/14/2026. Please note that prices are subject to change without notice.
Key Features:
- Extension for 7" H Tow Ramps
- Further decreases angle of approach for low-profile cars
- May also be used as a "humper" ramp
Technology & Features
Technology & Features
Specifications
Made in the USA
Sold As:
Pair
Length:
35"
Width:
10"
Height:
1-9/10"
Weight:
6 lbs.
Maximum Capacity:
1,500 lbs.
Color:
Black
Material:
Expanded foam with traction coating
More Information
This set of two XTenders can only be used with 7-inch lift HD Tow Ramps to further lower the angle of approach. Simply place the XTenders on top of the Tow Ramps and drive on up!
The XTenders can also be inverted for use as a "œhumper" ramp to get a bit of additional lift when needed. They are 10 inches wide and 35 inches long, weighing 6 pounds each.
These extenders are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong yet durable. They will not slide, scratch, or otherwise damage any floor type. The reinforced bottom allows them to grip tow ramps and to be used on gravel or other rough surfaces that you may encounter along the side of the road.
- Extension for 7" H Tow Ramps
- Further decreases angle of approach for low-profile cars
- May also be used as a "humper" ramp
Usage Guidelines
Before using the ramps ensure other persons are clear of the vehicle and the ramps. Ensure that the ramps are free from damage or corrosion before use. Use only a single pair of wheel ramps at the front or rear, do not use two ramps on one side of the vehicle. Position the ramps in line with the wheels, with the steering wheel pointed straight and the incline against the tire tread. Carefully drive the vehicle onto the automotive ramps until it is in the correct position. Turn the engine off, apply the parking brake, get out of the vehicle and securely chock the remaining wheels on the ground. Before starting work, walk around the vehicle ensuring it is securely positioned. Always use jack stand if a person will be going under the vehicle. On completion of the work, check the parking brake is still firmly on and remove the chocks. It is important to drive very slowly when coming off the ramps to prevent the automotive bodywork from making contact with the car ramp. Exercise caution when using these car ramps with a trailer or three wheeled vehicle.
Calculator
Make sure you can sail right up your service ramps!
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.
YARDSTICK TEST
1
Place a 36" yardstick or tape measure at the base of your front wheel.
2
Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).
3
Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.
Record your height here.
Reviews
Reviews
Q&A
Q&A