Extra Inclines for Restyler Ramps
Key Features:
- Extra set of Inclines for the 16" Restyler Magna Ramps
- Added convenience for drive-up and down
- Set of two
For the ultimate in drive-on/drive-off convenience, pick up an extra set of inclines for your 16-inch Restyler Ramps. With this set of two inclines, you can smoothly drive up onto the platform, complete your work, and drive forward to smoothly exit the platform.
With the standard Restyler set-up, you have to reverse down the inclines, or move them around to the front side, which can get cumbersome if you work on multiple cars in a day. These inclines have the same specifications as the pair in the standard Restyler package. They work with tires up to 14 inches wide, and have a 10.4-degree angle of approach. They can support up to 1,500 pounds per ramp for a total weight capacity of 6,000 pounds.
These inclines are manufactured using an exclusive, patented process. It is constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. It won't slide on any surface, including garage and workroom floors.
- Extra set of Inclines for the 16" Restyler Magna Ramps
- Added convenience for drive-up and down
- Set of two
Use the calculator below to determine your vehicle's maximum angle of approach. Then shop for any Race Ramps with an angle equal to or less than your result.
To determine the best angle of approach for your vehicle, we have devised the “yardstick test” below. If you do not have a yardstick, carefully measure out 36" with a tape measure or other straight, rigid object.
You may need two sets of hands to get an accurate measurement.


Place a 36" yardstick or tape measure at the base of your front wheel.

Raise up the yardstick or tape measure until it hits the underside of your car (the spoiler/splitter/air dam).

Measure vertically from the ground to the end of the yardstick or 36" point on the tape measure.